-
Je něco špatně v tomto záznamu ?
Dissolution kinetics of Pd and Pt from automobile catalysts by naturally occurring complexing agents
O. Sebek, M. Mihaljevič, L. Strnad, V. Ettler, J. Ježek, R. Stědrý, P. Drahota, L. Ackerman, V. Adamec,
Jazyk angličtina Země Nizozemsko
Typ dokumentu časopisecké články, práce podpořená grantem
- MeSH
- automobily MeSH
- katalýza MeSH
- kinetika MeSH
- mikroskopie elektronová rastrovací MeSH
- palladium chemie MeSH
- platina chemie MeSH
- rozpustnost MeSH
- výfukové emise vozidel MeSH
- Publikační typ
- časopisecké články MeSH
- práce podpořená grantem MeSH
Powder samples prepared from gasoline (Pt, Pd, Rh, new GN/old GO) and diesel (Pt, new DN/old DO) catalysts and recycled catalyst NIST 2556 were tested using kinetic leaching experiments following 1, 12, 24, 48, 168, 360, 720 and 1440-h interactions with solutions of 20mM citric acid (CA), 20 mM Na(2)P(4)O(7) (NaPyr), 1 g L(-1) NaCl (NaCl), a fulvic acid solution (FA-DOC 50 mg L(-1)) and 20 mM CA at pH 3, 4, 5, 6, 7, 8 and 9. The mobilisation of platinum group elements (PGEs) was fastest in solutions of CA and NaPyr. In the other interactions (NaCl, FA), the release of PGEs was probably followed by immobilisation processes, and the interactions were not found to correspond to the simple release of PGEs into solution. Because of their low concentrations, the individual complexing agents did not have any effect on the speciation of Pd and Pt in the extracts; both metals are present in solution as the complexes Me(OH)(2), Me(OH)(+). Immobilisation can take place through the adsorption of the positively charged hydroxyl complexes or flocculation of fulvic acid, complexing the PGEs on the surface of the extracted catalysts. The calculated normalised bulk released NRi values are similar to the reaction rate highest in the solutions of CA and NaPyr.
Citace poskytuje Crossref.org
- 000
- 00000naa a2200000 a 4500
- 001
- bmc12024288
- 003
- CZ-PrNML
- 005
- 20121207115343.0
- 007
- ta
- 008
- 120815e20111021ne f 000 0#eng||
- 009
- AR
- 024 7_
- $a 10.1016/j.jhazmat.2011.10.051 $2 doi
- 035 __
- $a (PubMed)22078491
- 040 __
- $a ABA008 $b cze $d ABA008 $e AACR2
- 041 0_
- $a eng
- 044 __
- $a ne
- 100 1_
- $a Sebek, Ondřej $u Laboratories of the Geological Institutes, Faculty of Science, Charles University in Prague, Prague, Czech Republic.
- 245 10
- $a Dissolution kinetics of Pd and Pt from automobile catalysts by naturally occurring complexing agents / $c O. Sebek, M. Mihaljevič, L. Strnad, V. Ettler, J. Ježek, R. Stědrý, P. Drahota, L. Ackerman, V. Adamec,
- 520 9_
- $a Powder samples prepared from gasoline (Pt, Pd, Rh, new GN/old GO) and diesel (Pt, new DN/old DO) catalysts and recycled catalyst NIST 2556 were tested using kinetic leaching experiments following 1, 12, 24, 48, 168, 360, 720 and 1440-h interactions with solutions of 20mM citric acid (CA), 20 mM Na(2)P(4)O(7) (NaPyr), 1 g L(-1) NaCl (NaCl), a fulvic acid solution (FA-DOC 50 mg L(-1)) and 20 mM CA at pH 3, 4, 5, 6, 7, 8 and 9. The mobilisation of platinum group elements (PGEs) was fastest in solutions of CA and NaPyr. In the other interactions (NaCl, FA), the release of PGEs was probably followed by immobilisation processes, and the interactions were not found to correspond to the simple release of PGEs into solution. Because of their low concentrations, the individual complexing agents did not have any effect on the speciation of Pd and Pt in the extracts; both metals are present in solution as the complexes Me(OH)(2), Me(OH)(+). Immobilisation can take place through the adsorption of the positively charged hydroxyl complexes or flocculation of fulvic acid, complexing the PGEs on the surface of the extracted catalysts. The calculated normalised bulk released NRi values are similar to the reaction rate highest in the solutions of CA and NaPyr.
- 650 _2
- $a automobily $7 D001336
- 650 _2
- $a katalýza $7 D002384
- 650 _2
- $a kinetika $7 D007700
- 650 _2
- $a mikroskopie elektronová rastrovací $7 D008855
- 650 _2
- $a palladium $x chemie $7 D010165
- 650 _2
- $a platina $x chemie $7 D010984
- 650 _2
- $a rozpustnost $7 D012995
- 650 _2
- $a výfukové emise vozidel $7 D001335
- 655 _2
- $a časopisecké články $7 D016428
- 655 _2
- $a práce podpořená grantem $7 D013485
- 700 1_
- $a Mihaljevič, Martin
- 700 1_
- $a Strnad, Ladislav
- 700 1_
- $a Ettler, Vojtěch
- 700 1_
- $a Ježek, Josef
- 700 1_
- $a Stědrý, Robin
- 700 1_
- $a Drahota, Petr
- 700 1_
- $a Ackerman, Lukáš $7 gn_A_00001004
- 700 1_
- $a Adamec, Vladimír $7 gn_A_00001266
- 773 0_
- $w MED00180297 $t Journal of hazardous materials $x 1873-3336 $g Roč. 198(20111021), s. 331-9
- 856 41
- $u https://pubmed.ncbi.nlm.nih.gov/22078491 $y Pubmed
- 910 __
- $a ABA008 $b sig $c sign $y m
- 990 __
- $a 20120815 $b ABA008
- 991 __
- $a 20121207115417 $b ABA008
- 999 __
- $a ok $b bmc $g 946436 $s 781616
- BAS __
- $a 3
- BAS __
- $a PreBMC
- BMC __
- $a 2011 $b 198 $d 331-9 $e 20111021 $i 1873-3336 $m Journal of hazardous materials $n J Hazard Mater $x MED00180297
- LZP __
- $a Pubmed-20120815/12/02