BACKGROUND: Color stability is a crucial performance parameter for dental restorations, and limited research exists on how surface preparation methods affect it. The purpose of this study was to test the color stability of three resins intended for 3D printing, which can be used to make dentures or crowns in A2 and A3 colors. MATERIALS AND METHODS: Samples were prepared in the form of incisors; the first group was not subjected to any treatment after curing and washing with alcohol, the second was covered with light-curing varnish, and the third was polished in a standard way. Then, the samples were placed in solutions of coffee, red wine, and distilled water and stored in the laboratory. After 14, 30, and 60 days, color changes were measured (presented as Delta E) compared to material stored in the dark. RESULTS: The greatest changes were observed for samples that were not polished, then were placed in red wine dilutions (ΔE = 18.19 ± 0.16). Regarding the samples covered with varnish, during storage, some parts detached, and the dyes penetrated inside. CONCLUSIONS: 3D-printed material should be polished as thoroughly as possible to limit the adhesion of dyes from food to their surface. Applying varnish may be a temporary solution.

Department of Advanced Material Technologies Faculty of Chemistry Wroclaw University of Science and Technology Smoluchowskiego 25 50 372 Wroclaw Poland

Department of Dentofacial Orthopaedics and Orthodontics Division of Facial Abnormalities Wroclaw Medical University Krakowska 26 50 425 Wroclaw Poland

SpofaDental Markova 238 506 01 Jicin Czech Republic

References provided by Crossref.org