-
Je něco špatně v tomto záznamu ?
The Effect of a Deproteinizing Pretreatment on the Bonding Performance and Acid Resistance of a Two-step Self-etch Adhesive on Eroded Dentin
Y. Yang, G. Inoue, K. Hosaka, A. Tichy, M. Ikeda, J. Tagami, Y. Shimada
Jazyk angličtina Země Spojené státy americké
Typ dokumentu časopisecké články
PubMed
38019217
DOI
10.2341/23-005-l
Knihovny.cz E-zdroje
- MeSH
- dentin MeSH
- dentinová adheziva farmakologie chemie MeSH
- lidé MeSH
- pevnost v tahu MeSH
- pryskyřičné cementy farmakologie chemie MeSH
- testování materiálů MeSH
- vazba zubní * metody MeSH
- zubní cementy * MeSH
- Check Tag
- lidé MeSH
- Publikační typ
- časopisecké články MeSH
OBJECTIVES: This study evaluated how deproteinization using sodium hypochlorite (6% NaOCl) or hypochlorous acid (50 ppm HOCl) with or without the subsequent use of an arylsulfinate salt-containing agent (Clearfil DC Activator; DCA; Kuraray Noritake Dental) affects the micro-tensile bond strength (μTBS) and formation of an acid-base resistant zone (ABRZ) of a two-step self-etch adhesive on eroded dentin. METHODS: Coronal dentin surfaces of sound human molars were exposed to 48 cycles of demineralization (1% citric acid; 5 minutes) and remineralization (buffer solution with pH=6.4; 3.5 hours). They were then assigned to experimental groups according to the pretreatment used: none (negative control), NaOCl, NaOCl+DCA, HOCl, and HOCl+DCA. Sound dentin surfaces with no pretreatment were used as a positive control. The dentin surfaces were bonded with Clearfil SE Bond 2 (Kuraray Noritake Dental), and μTBS was measured either after 24 hours or 20,000 thermal cycles (TC). The μTBS data were statistically analyzed using a mixed-model analysis of variance (ANOVA) and t-tests with Bonferroni correction. Failure mode was determined with scanning electron microscopy (SEM), which was also used for the observation of ABRZ. RESULTS: Among experimental groups, there was no significant difference between the negative control, HOCl, and HOCl+DCA after 24 hours, but the HOCl-pretreated groups exhibited significantly higher μTBS than the negative control after TC (p<0.01). Pretreatment with NaOCl and NaOCl+DCA resulted in significantly higher μTBS (p<0.001), but the highest μTBS was measured on sound dentin (p<0.001). TC decreased μTBS significantly in all groups (p<0.001) except for sound dentin and NaOCl+DCA (p>0.05). Adhesive failures prevailed in eroded groups, whereas cohesive failures were predominant on sound dentin. ABRZ was recognized in all groups but marked morphological differences were observed. CONCLUSIONS: The combined use of 6% NaOCl and the arylsulfinate salt-containing agent partially reversed the compromised bonding performance on eroded dentin, while the effect of 50 ppm HOCl was negligible.
Citace poskytuje Crossref.org
- 000
- 00000naa a2200000 a 4500
- 001
- bmc24007774
- 003
- CZ-PrNML
- 005
- 20240423160241.0
- 007
- ta
- 008
- 240412s2024 xxu f 000 0|eng||
- 009
- AR
- 024 7_
- $a 10.2341/23-005-L $2 doi
- 035 __
- $a (PubMed)38019217
- 040 __
- $a ABA008 $b cze $d ABA008 $e AACR2
- 041 0_
- $a eng
- 044 __
- $a xxu
- 100 1_
- $a Yang, Y $u Yi Yang, DDS, PhD student, Department of Cariology and Operative Dentistry, Graduate School of Medical and Dental Sciences, Tokyo Medical and Dental University, Tokyo, Japan
- 245 14
- $a The Effect of a Deproteinizing Pretreatment on the Bonding Performance and Acid Resistance of a Two-step Self-etch Adhesive on Eroded Dentin / $c Y. Yang, G. Inoue, K. Hosaka, A. Tichy, M. Ikeda, J. Tagami, Y. Shimada
- 520 9_
- $a OBJECTIVES: This study evaluated how deproteinization using sodium hypochlorite (6% NaOCl) or hypochlorous acid (50 ppm HOCl) with or without the subsequent use of an arylsulfinate salt-containing agent (Clearfil DC Activator; DCA; Kuraray Noritake Dental) affects the micro-tensile bond strength (μTBS) and formation of an acid-base resistant zone (ABRZ) of a two-step self-etch adhesive on eroded dentin. METHODS: Coronal dentin surfaces of sound human molars were exposed to 48 cycles of demineralization (1% citric acid; 5 minutes) and remineralization (buffer solution with pH=6.4; 3.5 hours). They were then assigned to experimental groups according to the pretreatment used: none (negative control), NaOCl, NaOCl+DCA, HOCl, and HOCl+DCA. Sound dentin surfaces with no pretreatment were used as a positive control. The dentin surfaces were bonded with Clearfil SE Bond 2 (Kuraray Noritake Dental), and μTBS was measured either after 24 hours or 20,000 thermal cycles (TC). The μTBS data were statistically analyzed using a mixed-model analysis of variance (ANOVA) and t-tests with Bonferroni correction. Failure mode was determined with scanning electron microscopy (SEM), which was also used for the observation of ABRZ. RESULTS: Among experimental groups, there was no significant difference between the negative control, HOCl, and HOCl+DCA after 24 hours, but the HOCl-pretreated groups exhibited significantly higher μTBS than the negative control after TC (p<0.01). Pretreatment with NaOCl and NaOCl+DCA resulted in significantly higher μTBS (p<0.001), but the highest μTBS was measured on sound dentin (p<0.001). TC decreased μTBS significantly in all groups (p<0.001) except for sound dentin and NaOCl+DCA (p>0.05). Adhesive failures prevailed in eroded groups, whereas cohesive failures were predominant on sound dentin. ABRZ was recognized in all groups but marked morphological differences were observed. CONCLUSIONS: The combined use of 6% NaOCl and the arylsulfinate salt-containing agent partially reversed the compromised bonding performance on eroded dentin, while the effect of 50 ppm HOCl was negligible.
- 650 _2
- $a lidé $7 D006801
- 650 12
- $a zubní cementy $7 D003738
- 650 12
- $a vazba zubní $x metody $7 D001840
- 650 _2
- $a dentinová adheziva $x farmakologie $x chemie $7 D017220
- 650 _2
- $a dentin $7 D003804
- 650 _2
- $a testování materiálů $7 D008422
- 650 _2
- $a pryskyřičné cementy $x farmakologie $x chemie $7 D019279
- 650 _2
- $a pevnost v tahu $7 D013718
- 655 _2
- $a časopisecké články $7 D016428
- 700 1_
- $a Inoue, G $u *Go Inoue, DDS, PhD, Department of Cariology and Operative Dentistry, Graduate School of Medical and Dental Sciences, Tokyo Medical and Dental University, Tokyo, Japan
- 700 1_
- $a Hosaka, K $u Keiichi Hosaka, DDS, PhD, Department of Regenerative Dental Medicine, Tokushima University Graduate School of Biomedical Sciences, Tokushima, Japan
- 700 1_
- $a Tichy, A $u Antonin Tichy, DDS, PhD, Department of Cariology and Operative Dentistry, Graduate School of Medical and Dental Sciences, Tokyo Medical and Dental University, Tokyo, Japan; Institute of Dental Medicine, First Faculty of Medicine of the Charles University and General University Hospital in Prague, Prague, Czech Republic
- 700 1_
- $a Ikeda, M $u Masaomi Ikeda, DDS, PhD, Department of Oral Prosthetic Engineering, Graduate School of Medical and Dental Sciences, Tokyo Medical and Dental University, Tokyo, Japan
- 700 1_
- $a Tagami, J $u Junji Tagami, DDS, PhD, Department of Operative Dentistry, Faculty of Dentistry, Chulalongkorn University, Bangkok, Thailand
- 700 1_
- $a Shimada, Y $u Yasushi Shimada, DDS, PhD, Department of Cariology and Operative Dentistry, Graduate School of Medical and Dental Sciences, Tokyo Medical and Dental University, Tokyo, Japan
- 773 0_
- $w MED00003609 $t Operative dentistry $x 1559-2863 $g Roč. 49, č. 1 (2024), s. 65-75
- 856 41
- $u https://pubmed.ncbi.nlm.nih.gov/38019217 $y Pubmed
- 910 __
- $a ABA008 $b sig $c sign $y - $z 0
- 990 __
- $a 20240412 $b ABA008
- 991 __
- $a 20240423160237 $b ABA008
- 999 __
- $a ok $b bmc $g 2081639 $s 1217541
- BAS __
- $a 3
- BAS __
- $a PreBMC-MEDLINE
- BMC __
- $a 2024 $b 49 $c 1 $d 65-75 $e 20240101 $i 1559-2863 $m Operative dentistry $n Oper. dent. $x MED00003609
- LZP __
- $a Pubmed-20240412