Modified aluminosilicates as low-cost sorbents of As(III) from anoxic groundwater
Language English Country Netherlands Media print-electronic
Document type Evaluation Study, Journal Article, Research Support, Non-U.S. Gov't
PubMed
18990496
DOI
10.1016/j.jhazmat.2008.09.088
PII: S0304-3894(08)01431-3
Knihovny.cz E-resources
- MeSH
- Adsorption MeSH
- Arsenic isolation & purification MeSH
- Bentonite MeSH
- Water Pollutants, Chemical isolation & purification MeSH
- Water Purification methods MeSH
- Kaolin MeSH
- Aluminum Silicates chemistry MeSH
- Publication type
- Journal Article MeSH
- Evaluation Study MeSH
- Research Support, Non-U.S. Gov't MeSH
- Names of Substances
- Arsenic MeSH
- Bentonite MeSH
- Water Pollutants, Chemical MeSH
- Kaolin MeSH
- Aluminum Silicates MeSH
The utilization of low-grade clay materials as selective sorbents represents one of the most effective possibilities of As removal from contaminated water reservoirs. The simple pre-treatment of these materials with Fe (Al, Mn) salts can significantly improve their sorption affinity to As oxyanions. The natural kaolin calcined at 550 degrees C (mostly metakaolin) and raw bentonite (mostly montmorillonite) pre-treated with Fe(II), Fe(III), Al(III) and Mn(II) salts were used to remove of As from the model anoxic groundwater with As(III) concentration about 0.5 and 10 mg L(-1). All the pre-treating methods were appropriate for bentonite; the efficiency of As(III) sorption varied from 92 to >99%, by the sorption capacity higher than 4.5 mg g(-1). In the case of metakaolin, Fe(II)- and Mn(II)-treatments proved the high sorption efficiency (>97%), while only <50% of As was removed after Fe(III) and Al(III) pre-treatment. The sorption capacities of treated metakaolin ranged from 0.1 to 2.0 mg g(-1).
References provided by Crossref.org
Adsorption of Phosphate and Ammonium on Waste Building Sludge