The pH-dependent leaching behavior of slags from various stages of a copper smelting process: Environmental implications
Jazyk angličtina Země Velká Británie, Anglie Médium print-electronic
Typ dokumentu časopisecké články
PubMed
27889660
DOI
10.1016/j.jenvman.2016.11.037
PII: S0301-4797(16)30919-7
Knihovny.cz E-zdroje
- Klíčová slova
- Copper slag, Modeling, Slag re-processing, Solubility controls, pH-dependent leaching,
- MeSH
- arseničnany MeSH
- Evropská unie MeSH
- hornictví MeSH
- hutnictví metody MeSH
- kovy MeSH
- látky znečišťující životní prostředí analýza MeSH
- měď * MeSH
- nebezpečný odpad zákonodárství a právo MeSH
- odpadní produkty analýza MeSH
- životní prostředí * MeSH
- Publikační typ
- časopisecké články MeSH
- Geografické názvy
- Namibie MeSH
- Názvy látek
- arseničnany MeSH
- kovy MeSH
- látky znečišťující životní prostředí MeSH
- měď * MeSH
- nebezpečný odpad MeSH
- odpadní produkty MeSH
The leaching behaviors of primary copper (Cu) slags originating from Ausmelt, reverbatory, and converter furnaces operating under a single technological process were compared to a residual slag tailing obtained by slag re-processing via flotation and metal recovery. The EN 12457-2 leaching test, used for assessment of the hazardous properties, was followed by the CEN/TS 14997 pH-static leaching test (pH range 3-12). Both leaching experiments were coupled with a mineralogical investigation of the primary and secondary phases as well as geochemical modeling. Metals (Cd, Cu, Pb, Zn) exhibit the highest leaching at low pH. Under acidic conditions (pH 3-6), Ausmelt slag and slag tailing exhibited higher metal leaching compared to other slag types. Very low leaching of metals (far below EU limits for non-hazardous waste) was observed at natural pH (7.9-9.0) for all the studied slag samples. In contrast, relatively high leaching of As was observed over the entire pH range, especially for Ausmelt slag (exceeding the EU limit for hazardous waste by 1.7×). However, geochemical modeling and scanning electron microscopy indicated that formation of stable Ca-Cu-Pb arsenates and the binding of As to newly formed Fe (oxyhydr)oxides play an important role in efficient As immobilization at the slag-water interface. In contrast, no controls were predicted for Sb, whose leaching was almost pH-independent. Nevertheless Sb leached concentrations at natural pH were below EU limit for hazardous waste. Re-processing of primary Cu slags for metal recovery, and subsequent co-disposal of the resulting slag tailing with dolomite-rich mine tailing and local laterite is suitable for stabilizing the remaining contaminants (except Sb) and limiting their leaching into the environment.
Czech Geological Survey Geologická 6 152 00 Prague 5 Czechia
Department of Geology Faculty of Science University of Namibia Private Bag 13301 Windhoek Namibia
Citace poskytuje Crossref.org