In this work, we tried to analyze dust loading behavior of polypropylene hollow fiber membranes using average pressure drop models. Hollow fiber membranes varying in fiber diameter were loaded with a standardized test dust to simulate particle-polluted air. We measured pressure drop development of the membranes at different flowrates and dust concentrations, and, after each experiment, the dust deposited on the membrane fibers was weighed to obtain dust holding capacity (DHC). The obtained experimental data was analyzed using various average pressure drop models and compared with average pressure drop obtained from pressure drop/dust load dependence using a curve fit. Exponential and polynomial fitting was used and compared. Pressure drop in relation to the dust load followed different trends depending on the experimental conditions and inner fiber diameter. At higher flowrate, the dependence was polynomial no matter what the fiber diameter. However, with higher fiber diameter at lower permeate velocities, the dependence was close to exponential curve and followed similar trends as observed in planar filter media. Dust-holding capacity of the membranes depended on the experimental conditions and was up to 21.4 g. However, higher dust holding capacity was impossible to reach no matter the experiment duration due to self-cleaning ability of the tested membranes.

Heat Transfer and Fluid Flow Laboratory Faculty of Mechanical Engineering Brno University of Technology 61669 Brno Czech Republic

ZENA Membranes s r o 62100 Brno Czech Republic

See more in PubMed

Chen J., Brager G.S., Augenbroe G., Song X. Impact of Outdoor Air Quality on the Natural Ventilation Usage of Commercial Buildings in the US. Appl. Energy. 2019;235:673–684. doi: 10.1016/j.apenergy.2018.11.020. DOI

Yu B.F., Hu Z.B., Liu M., Yang H.L., Kong Q.X., Liu Y.H. Review of Research on Air-Conditioning Systems and Indoor Air Quality Control for Human Health. Int. J. Refrig. 2009;32:3–20. doi: 10.1016/j.ijrefrig.2008.05.004. DOI

Bulejko P. An Analysis on Energy Demands in Airborne Particulate Matter Filtration Using Hollow-Fiber Membranes. Energy Rep. 2021;7:2727–2736. doi: 10.1016/j.egyr.2021.05.005. DOI

Leung W.W.-F., Hau C.W.-Y. A Model of Backpulse and Backblow Cleaning of Nanofiber Filter Loaded with Nano-Aerosols. Sep. Purif. Technol. 2016;169:171–178. doi: 10.1016/j.seppur.2016.06.007. PubMed DOI PMC

Leung W.W.-F., Hau C.W.Y. Skin Layer in Cyclic Loading-Cleaning of a Nanofiber Filter in Filtering Nano-Aerosols. Sep. Purif. Technol. 2017;188:367–378. doi: 10.1016/j.seppur.2017.07.043. PubMed DOI PMC

Bulejko P., Krištof O., Dohnal M., Svěrák T. Fine/Ultrafine Particle Air Filtration and Aerosol Loading of Hollow-Fiber Membranes: A Comparison of Mathematical Models for the Most Penetrating Particle Size and Dimensionless Permeability with Experimental Data. J. Membr. Sci. 2019;592:117393. doi: 10.1016/j.memsci.2019.117393. DOI

Bulejko P. Numerical Comparison of Prediction Models for Aerosol Filtration Efficiency Applied on a Hollow-Fiber Membrane Pore Structure. Nanomaterials. 2018;8:447. doi: 10.3390/nano8060447. PubMed DOI PMC

Wang L.-Y., Yu L.E., Chung T.-S. Effects of Relative Humidity, Particle Hygroscopicity, and Filter Hydrophilicity on Filtration Performance of Hollow Fiber Air Filters. J. Membr. Sci. 2020;595:117561. doi: 10.1016/j.memsci.2019.117561. DOI

Bulejko P., Krištof O., Svěrák T. Experimental and Modeling Study on Fouling of Hollow-Fiber Membranes by Fine Dust Aerosol Particles. J. Membr. Sci. 2020;616:118562. doi: 10.1016/j.memsci.2020.118562. DOI

Bulejko P., Svěrák T., Dohnal M., Pospíšil J. Aerosol Filtration Using Hollow-Fiber Membranes: Effect of Permeate Velocity and Dust Amount on Separation of Submicron TiO2 Particles. Powder Technol. 2018;340:344–353. doi: 10.1016/j.powtec.2018.09.040. DOI

Xu H., Jin W., Wang F., Li C., Wang J., Zhu H., Guo Y. Preparation and Properties of PTFE Hollow Fiber Membranes for the Removal of Ultrafine Particles in PM2.5 with Repetitive Usage Capability. RSC Adv. 2018;8:38245–38258. doi: 10.1039/C8RA07789D. PubMed DOI PMC

Sun C., Woodman D. Delivering Sustainability Promise to HVAC Air Filtration-Part I: Classification of Energy Efficiency for Air Filters. ASHRAE Trans. 2009;115:581–585.

Eurovent 4/21—2014: Calculation Method for the Energy Use Related to Air Filters in General Ventilation Systems—First Edition | Eurovent. [(accessed on 11 November 2020)]; Available online: https://eurovent.eu/?q=content/eurovent-421-2014-calculation-method-energy-use-related-air-filters-general-ventilation.

Zhang W., Deng S., Wang Y., Lin Z. Dust Loading Performance of the PTFE HEPA Media and Its Comparison with the Glass Fibre HEPA Media. Aerosol Air Qual. Res. 2018;18:1921–1931. doi: 10.4209/aaqr.2017.11.0481. DOI

Long J., Tang M., Sun Z., Liang Y., Hu J. Dust Loading Performance of a Novel Submicro-Fiber Composite Filter Medium for Engine. Materials. 2018;11:2038. doi: 10.3390/ma11102038. PubMed DOI PMC

Sun C. Delivering Sustainability Promise to HVAC Air Filtration: Part II: Life Cycle Sustainability of Air Filters. ASHRAE Trans. 2010;116:25–32.

Montgomery J.F., Green S.I., Rogak S.N., Bartlett K. Predicting the Energy Use and Operation Cost of HVAC Air Filters. Energy Build. 2012;47:643–650. doi: 10.1016/j.enbuild.2012.01.001. DOI

Zena Membranes s.r.O. [(accessed on 14 May 2021)]; Available online: www.zena-membranes.cz/

Sverak T., Bulejko P., Ostrezi J., Kristof O., Kalivoda J., Kejik P., Mayerova K., Adamcik M. Separation of Gaseous Air Pollutants Using Membrane Contactors. IOP Conf. Ser. Earth Environ. Sci. 2017;92:012061. doi: 10.1088/1755-1315/92/1/012061. DOI

Kůdelová T., Bartuli E., Strunga A., Hvožďa J., Dohnal M. Fully Polymeric Distillation Unit Based on Polypropylene Hollow Fibers. Polymers. 2021;13:1031. doi: 10.3390/polym13071031. PubMed DOI PMC

ASHRAE 52.2-2017 . Method of Testing General Ventilation Air-Cleaning Devices for Removal Efficiency by Particle Size. ASHRAE; Peachtree Corners, GA, USA: 2017. (ANSI Approved)

Bulejko P., Dohnal M., Pospíšil J., Svěrák T. Air Filtration Performance of Symmetric Polypropylene Hollow-Fibre Membranes for Nanoparticle Removal. Sep. Purif. Technol. 2018;197:122–128. doi: 10.1016/j.seppur.2017.12.056. DOI

Zhang X., Liu J., Liu X., Liu C. Performance Optimization of Airliner Cabin Air Filters. Build. Environ. 2021;187:107392. doi: 10.1016/j.buildenv.2020.107392. DOI

Banik R., Das P., Ray S., Biswas A. Prediction of Electrical Energy Consumption Based on Machine Learning Technique. Electr. Eng. 2020 doi: 10.1007/s00202-020-01126-z. DOI

Maduna L., Patnaik A. Textiles in Air Filtration. Text. Prog. 2017;49:173–247. doi: 10.1080/00405167.2018.1461921. DOI

Azimi P., Stephens B. HVAC Filtration for Controlling Infectious Airborne Disease Transmission in Indoor Environments: Predicting Risk Reductions and Operational Costs. Build. Environ. 2013;70:150–160. doi: 10.1016/j.buildenv.2013.08.025. PubMed DOI PMC

Tian X., Ou Q., Liu J., Liang Y., Pui D.Y.H. Influence of Pre-Stage Filter Selection and Face Velocity on the Loading Characteristics of a Two-Stage Filtration System. Sep. Purif. Technol. 2019;224:227–236. doi: 10.1016/j.seppur.2019.05.031. DOI

Walsh D.C. Possibilities for the Design of Fibrous Filter Materials with Enhanced Dust Holding Capacity. J. Aerosol Sci. 1998;29:S939–S940. doi: 10.1016/S0021-8502(98)90652-8. DOI

Chang D.-Q., Tien C.-Y., Peng C.-Y., Tang M., Chen S.-C. Development of Composite Filters with High Efficiency, Low Pressure Drop, and High Holding Capacity PM2.5 Filtration. Sep. Purif. Technol. 2019;212:699–708. doi: 10.1016/j.seppur.2018.11.068. DOI

Rebai M., Prat M., Meireles M., Schmitz P., Baclet R. Clogging Modeling in Pleated Filters for Gas Filtration. Chem. Eng. Res. Des. 2010;88:476–486. doi: 10.1016/j.cherd.2009.08.014. DOI

Shao P., Huang R.Y.M. An Analytical Approach to the Gas Pressure Drop in Hollow Fiber Membranes. J. Membr. Sci. 2006;271:69–76. doi: 10.1016/j.memsci.2005.06.058. DOI

Tang M., Chen S.-C., Chang D.-Q., Xie X., Sun J., Pui D.Y.H. Filtration Efficiency and Loading Characteristics of PM2.5 through Composite Filter Media Consisting of Commercial HVAC Electret Media and Nanofiber Layer. Sep. Purif. Technol. 2018;198:137–145. doi: 10.1016/j.seppur.2017.03.040. DOI