The properties of MXene flakes, a new class of two-dimensional materials, are strictly determined by their surface termination. The most common termination groups are oxygen-containing (=O or -OH) and fluorine (-F), and their relative ratio is closely related to flake stability and catalytic activity. The surface termination can vary significantly among MXene flakes depending on the preparation route and is commonly determined after flake preparation by using X-ray photoelectron spectroscopy (XPS). In this paper, as an alternative approach, we propose the combination of surface-enhanced Raman spectroscopy (SERS) and artificial neural networks (ANN) for the precise and reliable determination of MXene flakes' (Ti3C2Tx) surface chemistry. Ti3C2Tx flakes were independently prepared by three scientific groups and subsequently measured using three different Raman spectrometers, employing resonant excitation wavelengths. Manual analysis of the SERS spectra did not enable accurate determination of the flake surface termination. However, the combined SERS-ANN approach allowed us to determine the surface termination with a high accuracy. The reliability of the method was verified by using a series of independently prepared samples. We also paid special attention to how the results of the SERS-ANN method are affected by the flake stability and differences in the conditions of flake preparation and Raman measurements. This way, we have developed a universal technique that is independent of the above-mentioned parameters, providing the results with accuracy similar to XPS, but enhanced in terms of analysis time and simplicity.
- Publikační typ
- časopisecké články MeSH
Humidity sensors play a critical role in monitoring human activities, environmental health, food processing and storage, and many other fields. Recently, some 2D materials, particularly MXenes, have been considered as promising candidates for creating humidity sensors because of their high surface area, surface-to-bulk ratio, and excellent conductivity, arising from the high concentration and mobility of free electrons. In this work, we propose the plasmon-assisted surface modification and termination tuning of common MXene (Ti3C2Tx) to enhance their response to humidity and increase their stability against oxidation. Hydrophobic (-C6H4-CF3) and hydrophilic (-C6H4-COOH) chemical moieties were covalently grafted to the Ti3C2Tx surface using plasmon-mediated diazonium chemistry. In situ Grazing-Incidence Wide-Angle X-ray Scattering (GIWAXS) measurements, performed at different humidity levels indicate that surface modification significantly affects penetration of water molecules in Ti3C2Tx films. As a result, the sensitivity of the flakes to the presence of water molecules was significantly altered. Additionally, proposed surface grafting commonly proceeds on the less stable MXene surface sites, where flake oxidation commonly initiates. As a result of the modification, such "weak" and more chemically active sites were blocked and Ti3C2Tx stability was significantly enhanced.
- Publikační typ
- časopisecké články MeSH
The influence of Mo on the electronic states and crystalline structure, as well as morphology, phase composition, luminescence, and defects in ZnO rods grown as free-standing nanoparticles, was studied using a variety of experimental techniques. Mo has almost no influence on the luminescence of the grown ZnO particles, whereas shallow donors are strongly affected in ZnO rods. Annealing in air causes exciton and defect-related bands to drop upon Mo doping level. The increase of the Mo doping level from 20 to 30% leads to the creation of dominating molybdates. This leads to a concomitant drop in the number of formed ZnO nanorods.
- Klíčová slova
- ZnO nanorods, electron paramagnetic resonance, luminescence, molybdenum doping, morphology,
- Publikační typ
- časopisecké články MeSH
We report on the formation of silver nanoparticles by gas aggregation in a reaction chamber at room temperature. The size distribution of nanoparticles deposited on a silicon substrate for various lengths of an aggregation (high-pressure) chamber was investigated by atomic force microscopy. Nanoparticles were characterized by scanning and transmission electron microscopy and spectral ellipsometry. The physical shape of the nanoparticles and its distribution was correlated with their optical properties. Metal-dielectric nanocomposites were deposited employing simultaneous deposition of Ag NPs via high-pressure magnetron sputtering and the dielectric matrix was deposited via thermal evaporation. Pure and Eu-, Er-, and Yb-doped lithium fluoride was used as the dielectric host matrix. Optical transmittance of lithium fluoride containing silver nanoparticles was measured and their theoretical absorption cross-section calculated. The nanoparticles were also embedded in Eu3+-doped downshifting and Er3+- and Yb3+-doped up-conversion materials to study their influence on emission spectra. Spectra of identical layers with and without nanoparticles were compared. Their transmittance at various annealing temperatures is also presented.
- Klíčová slova
- Ag nanoparticles, photoluminescence, surface plasmon resonance,
- Publikační typ
- časopisecké články MeSH
The recent advancements in pulsed laser deposition (PLD) control via plasma diagnostics techniques have been positive and raised questions on the limitation of some techniques, such as the Langmuir probe (LP). The particularities of laser-produced plasma can lead to incorrect interpretation of collected electrical signal. In this paper, we explored the limitations of LP as a technique for in situ PLD control by performing investigations on several metallic plasmas, expanding in various Ar atmosphere conditions. Sub-microsecond modulation was seen in the reconstructed IV characteristics attributed to non-equilibrium dynamics of the ejected charges. A perturbative regime was recorded for Ar pressures higher than 2 Pa, where ionic bursts were observed in the electron saturation region. This perturbation was identified as a plasma fireball. A non-linear multifractal model was developed here to explore these new regimes of the LP. The strange attractors characterizing each fireball were reconstructed, and their evolution with the Ar pressure is discussed. Both short- and long-time non-linear behavior were correlated via probe bias, and the pressure effect on the strange attractor's defining the fireball-like behavior was investigated. A good correlation was noticed between the simulated data and experimental findings.
- Klíčová slova
- Langmuir probe, laser-produced plasmas, multifractal model, perturbative regime, strange attractors,
- Publikační typ
- časopisecké články MeSH
Cationic doping of ZnO nanorods has gained increased interest as it can lead to the production of materials with improved luminescent properties, electrical conductivity and stability. We report on various Mo-doped ZnO powders of nanorods synthesized by the hydrothermal growth method. Further annealing or/and cold hydrogen or oxygen plasma modification was applied. The atomic structure of the as-grown and plasma-modified rods was characterized by X-ray diffraction. To identify any possible changes in morphology, scanning electron microscopy was used. Paramagnetic point defects were investigated by electron paramagnetic resonance. In particular, two new types of defects were initiated by the plasma treatment. Their appearance was explained, and corresponding mechanisms were proposed. The changes in the luminescence and scintillation properties were characterized by photo- and radioluminescence, respectively. Charge trapping phenomena were studied by thermally stimulated luminescence. Cold plasma treatment influenced the luminescence properties of ZnO:Mo structures. The contact with hydrogen lead to an approximately threefold increase in intensity of the ultraviolet exciton-related band peaking at ~3.24 eV, whereas the red band attributed to zinc vacancies (~1.97 eV) was suppressed compared to the as-grown samples. The exciton- and defect-related emission subsided after the treatment in oxygen plasma.
- Klíčová slova
- EPR, Mo5+, photo-, radio- and cathodoluminescence, plasma treatment, shallow donors, zinc oxide nanorods,
- Publikační typ
- časopisecké články MeSH
Eu3+-doped oxide thin films possess a great potential for several emerging applications in optics, optoelectronics, and sensors. The applications demand maximizing Eu3+ photoluminescence response. Eu-doped ZnO, TiO2, and Lu2O3 thin films were deposited by Pulsed Laser Deposition (PLD). Pulsed UV Laser Annealing (PLA) was utilized to modify the properties of the films. In situ monitoring of the evolution of optical properties (photoluminescence and transmittance) at PLA was realized to optimize efficiently PLA conditions. The changes in optical properties were related to structural, microstructural, and surface properties characterized by X-ray diffraction (XRD) and atomic force microscopy (AFM). The substantial increase of Eu3+ emission was observed for all annealed materials. PLA induces crystallization of TiO2 and Lu2O3 amorphous matrix, while in the case of already nanocrystalline ZnO, rather surface smoothening0related grains' coalescence was observed.
- Klíčová slova
- europium, in situ monitoring, lutetium oxide, photoluminescence, pulsed laser annealing, pulsed laser deposition, titanium oxide, zinc oxide,
- Publikační typ
- časopisecké články MeSH
The dynamics of transient plasma generated by UV ns-laser ablation of selected metals (Co, Cu, Ag, Bi) were investigated by the Langmuir Probe method in angle- and time-resolved modes. Multiple ionic and electronic structures were seen for all plasmas with some corresponding to anions or nanoparticle-dominated structures. The addition of an Ar atmosphere energetically confined the plasma and increased the charge density by several orders of magnitude. For pressure ranges exceeding 0.5 Pa fast ions were generated in the plasma as a result of Ar ionization and acceleration in the double layer defining the front of the plasma plume. Several correlations between the target nature plasma properties were attempted. The individual plasma structure expansion velocity increases with the melting point and decreases with the atomic mass while the corresponding charged particle densities decrease with the melting point, evidencing the relationship between the volatility of the sample and the overall abated mass.
- Klíčová slova
- Langmuir probe, laser produced plasmas, metals, plasma-target correlation,
- Publikační typ
- časopisecké články MeSH