This study presents the fabrication of highly photosensitive undoped zinc oxide (ZnO) thin films for vacuum ultraviolet (VUV) radiation detection, covering the wavelength range of 100-200 nm. ZnO films were deposited using hybrid pulsed reactive magnetron sputtering, assisted by ECWR (electron cyclotron wave resonance) plasma. Control of the ECWR power (PECWR), ranging from 0 to 380 W, played a crucial role in enhancing the films' photoconductive properties. At PECWR = 200 W, the photosensitivity increased by 8 orders of magnitude compared to films deposited without ECWR assistance. This improvement was attributed to a sharp reduction in dark current due to lower defect density. Photoluminescence and cathodoluminescence spectra revealed a significant reduction in defect-related emissions for films deposited at PECWR = 200 W, confirming fewer intrinsic defects. Raman spectroscopy also showed a decrease in defect-related vibrational modes in the same films. Time-Resolved Microwave Conductivity (TRMC) measurements further supported these findings, demonstrating rapid recombination of charge carriers at 200 W, indicative of low trap densities. These results suggest that precise control of ECWR power allows for optimization of the defect concentration and crystallinity in ZnO films, paving the way for the development of high-sensitivity VUV photodetectors.
- Klíčová slova
- Electron cyclotron wave resonance, Medium-frequency range magnetron sputtering, Photoconductive detector, Thin film, Vacuum ultraviolet, Zinc oxide,
- Publikační typ
- časopisecké články MeSH
We report on fabricated titanium dioxide (TiO2) thin films along with a transimpedance amplifier (TIA) test setup as a photoconductivity detector (sensor) in the ultraviolet-C (UV-C) wavelength region, particularly at 260 nm. TiO2 thin films deposited on high-resistivity undoped silicon-substrate at thicknesses of 100, 500, and 1000 nm exhibited photoresponsivities of 81.6, 55.6, and 19.6 mA/W, respectively, at 30 V bias voltage. Despite improvements in the crystallinity of the thicker films, the decrease in photocurrent, photoconductivity, photoconductance, and photoresponsivity in thicker films is attributed to an increased number of defects. Varying the thickness of the film can, however, be leveraged to control the wavelength response of the detector. Future development of a chip-based portable UV-C detector using TiO2 thin films will open new opportunities for a wide range of applications.
- Klíčová slova
- UV-C, photoconductive detector, sensor, thin film, titanium dioxide, transimpedance amplifier, ultraviolet,
- Publikační typ
- časopisecké články MeSH
Vacuum ultraviolet radiation (VUV, from 100 nm to 200 nm wavelength) is indispensable in many applications, but its detection is still challenging. We report the development of a VUV photoconductive detector, based on titanium dioxide (TiO2) nanoparticle thin films. The effect of crystallinity, optical quality, and crystallite size due to film thickness (80 nm, 500 nm, 1000 nm) and type of substrate (silicon Si, quartz SiO2, soda lime glass SLG) was investigated to explore ways of enhancing the photoconductivity of the detector. The TiO2 film deposited on SiO2 substrate with a film thickness of 80 nm exhibited the best photoconductivity, with a photocurrent of 5.35 milli-Amperes and a photosensitivity of 99.99% for a bias voltage of 70 V. The wavelength response of the detector can be adjusted by changing the thickness of the film as the cut-off shifts to a longer wavelength, as the film becomes thicker. The response time of the TiO2 detector is about 5.8 μs and is comparable to the 5.4 μs response time of a diamond UV sensor. The development of the TiO2 nanoparticle thin film detector is expected to contribute to the enhancement of the use of VUV radiation in an increasing number of important technological and scientific applications.
- Klíčová slova
- nanoparticle, photoconductive detector, semiconductor, thin film, titanium dioxide, vacuum ultraviolet, wide band gap,
- Publikační typ
- časopisecké články MeSH
Heterogeneous photocatalysis of TiO2 is one of the most efficient advanced oxidation processes for water and air purification. Here, we prepared hierarchical TiO2 layers (Spikelets) by hollow-cathode discharge sputtering and tested their photocatalytic performance in the abatement of inorganic (NO, NO2) and organic (4-chlorophenol) pollutant dispersed in air and water, respectively. The structural-textural properties of the photocatalysts were determined via variety of physico-chemical techniques (XRD, Raman spectroscopy, SEM, FE-SEM. DF-TEM, EDAX and DC measurements). The photocatalysis was carried out under conditions similar to real environment conditions. Although the abatement of NO and NO2 was comparable with that of industrial benchmark Aeroxide® TiO2 P25, the formation of harmful nitrous acid (HONO) product on the Spikelet TiO2 layers was suppressed. Similarly, in the decontamination of water by organics, the mineralization of 4-chlorophenol on Spikelet layers was interestingly the same, although their reaction rate constant was three-times lower. The possible explanation may be the more than half-magnitude order higher external quantum efficacy (EQE) compared to that of the reference TiO2 P25 layer. Therefore, such favorable kinetics and reaction selectivity, together with feasible scale-up, make the hierarchical TiO2 layers very promising photocatalyst which can be used for environmental remediation.
- Klíčová slova
- NOx and phenol abatement, P25, TiO2, external quantum efficiency, photocatalysis,
- Publikační typ
- časopisecké články MeSH
Hematite, α-Fe2O3, is considered as one of the most promising materials for sustainable hydrogen production via photoelectrochemical water splitting with a theoretical solar-to-hydrogen efficiency of 17%. However, the poor electrical conductivity of hematite is a substantial limitation reducing its efficiency in real experimental conditions. Despite of computing models suggesting that the electrical conductivity is extremely anisotropic, revealing up to 4 orders of magnitude higher electron transport with conduction along the (110) hematite crystal plane, synthetic approaches allowing the sole growth in that direction have not been reported yet. Here, we present a strategy for controlling the crystal orientation of very thin hematite films by adjusting energy of ion flux during advanced pulsed reactive magnetron sputtering technique. The texture and effect of the deposition mode on the film properties were monitored by XRD, conversion electron Mössbauer spectroscopy, XPS, SEM, AFM, PEC water splitting, IPCE, transient photocurrent measurements, and Mott-Schottky analysis. The precise control of the synthetic conditions allowed to fabricate hematite photoanodes exhibiting fully textured structures along (110) and (104) crystal planes with huge differences in photocurrents of 0.65 and 0.02 mA cm(-2) (both at 1.55 V versus RHE), respectively. The photocurrent registered for fully textured (110) film is among record values reported for thin planar films. Moreover, the developed fine-tuning of crystal orientation having a huge impact on the photoefficiency would induce further improvement of thin hematite films mainly if cation doping will be combined with the controllable texture.
- Klíčová slova
- Hematite, PEC water splitting, conversion electron Mössbauer spectroscopy, iron oxide, pulsed magnetron sputtering, texture,
- Publikační typ
- časopisecké články MeSH
- práce podpořená grantem MeSH
Effects of methoprene and 20-hydroxyecdysone on the development and hemagglutination activity (HA) were studied in both sexes of two members of the Culex pipiens complex-anautogenous C. p. quinquefasciatus and autogenous C. p. molestus. Juvenile hormone analogue (methoprene) and 20-hydroxyecdysone caused developmental changes in both mosquito strains. High larval mortality, prolongation of intermolt period in each larval instar and in the pupal stage, and morphological changes in the larval-pupal and pupal-adult transformations were also observed. Developmental changes were accompanied with some differences in the HA. HA was found in both sexes of both experimental mosquito strains. The juvenile hormone analogue used in the larval stage caused significant decrease of HA in the gut of adults of both sexes. On the other hand, 20-hydroxyecdysone decreased HA only in the female gut. Results obtained indicate that HA depends on the sex, the studied organ, and the level of hormones.
- MeSH
- Culex účinky léků fyziologie MeSH
- ekdysteron farmakologie MeSH
- hemaglutinace účinky léků MeSH
- methopren farmakologie MeSH
- zvířata MeSH
- Check Tag
- mužské pohlaví MeSH
- ženské pohlaví MeSH
- zvířata MeSH
- Publikační typ
- časopisecké články MeSH
- práce podpořená grantem MeSH
- Názvy látek
- ekdysteron MeSH
- methopren MeSH
