Graphite nanoplatelets
Dotaz
Zobrazit nápovědu
Structure and properties of poly(lactic acid) (PLA)/poly (ɛ-caprolactone) (PCL) influenced by graphite nanoplatelets (GNP) were studied in dependence on blend composition. Electron microscopy indicates predominant localization of GNP in PCL. GNP-induced changes in viscosity hinder refinement of PCL inclusions, support PCL continuity in the co-continuous system, and lead to reduction of PLA inclusions size without GNP being present at the interface in the PCL-matrix blend. Negligible differences in crystallinity of both phases indicate that mechanical behaviour is mainly influenced by reinforcement and GNP-induced changes in morphology. Addition of 5 parts of GNP leads to ~40% and ~25% increase of stiffness in the PCL- and PLA-matrix systems, respectively, whereas the reinforcing effect is practically eliminated in the co-continuous systems due to GNP-induced lower continuity of PLA which enhances toughness. Impact resistance of the 80/20 blend shows increase with 5 parts content due to synergistic effect of PCL/GNP stacks, whereas minor increase in the blend of the ductile PCL matrix with brittle PLA inclusions is caused by GNP-modification of the component parameters. Results indicate high potential of GNP in preparing biocompatible systems with wide range of structure and properties.
Addition of high-aspect-ratio (AR) nanofillers can markedly influence flow behavior of polymer systems. As a result, application of graphite nanoplatelets (GNP) allows preparation of microfibrillar composites (MFC) based on PCL matrix reinforced with in-situ generated PLA fibrils. This work deals, for the first time, with preparation of analogous melt-drawn fibers. Unlike other blend-based fibers, the spinning and melt drawing leads to structure of deformed inclusions due to unfavorable ratio of rheological parameters of components. Subsequent moderate cold drawing of the system with dissimilar deformability of components causes strengthening with PLA fibrils. Unexpectedly, high velocity and extent of cold drawing leads to structure with low-AR inclusions, similar to the original melt-drawn blend. Extensive fast deformation of the soft PCL matrix does not allow sufficient stress transfer to rigid PLA. In spite of peculiarities found, the GNP-aided melt spinning allows facile preparation of biodegradable biocompatible fibers with wide range of diameters (80-400 μm) and parameters (2.35-18 cN/tex).
