In the present work, a disposable microextraction device with a polyamide 6 nano-fibrous supported liquid membrane (SLM) is employed for the pretreatment of minute volumes of biological fluids. The device is placed in a sample vial for an at-line coupling to a commercial capillary electrophoresis instrument with UV-Vis detection (CE-UV) and injections are performed fully automatically from the free acceptor solution above the SLM with no contact between the capillary and the membrane. Up to 4-fold enrichment of model basic (nortriptyline, haloperidol, loperamide, and papaverine) and acidic (ibuprofen, naproxen, ketoprofen, and diclofenac) drugs is achieved by optimizing the ratio of the donor to the acceptor solution volumes (16 to 4 μL, respectively). The actual setup enables SLM extractions from less than a drop of sample and is suitable for pretreatment of scarce human body fluids. Two unique methods are reported for efficient clean-up and enrichment of the basic and acidic drugs from capillary blood (formed as dried blood spot), serum, and urine samples, which enable their determination at therapeutic and/or toxic levels. The hyphenation of the SLM extraction with CE-UV analysis provides good repeatability (RSD, 2.4-14.9%), linearity (r2, 0.988-1.000), sensitivity (LOD, 0.017-0.22 mg L-1), and extraction recovery (ER, 20-106%) at short extraction times (10 min) and with minimum consumption of samples and reagents. Graphical abstract.
- MeSH
- Electrophoresis, Capillary methods MeSH
- Hydrogen-Ion Concentration * MeSH
- Pharmaceutical Preparations metabolism MeSH
- Humans MeSH
- Membranes, Artificial * MeSH
- Liquid Phase Microextraction methods MeSH
- Nanofibers * MeSH
- Reproducibility of Results MeSH
- Body Fluids chemistry MeSH
- Check Tag
- Humans MeSH
- Publication type
- Journal Article MeSH
A simple analytical workflow is described for gas chromatographic-mass spectrometry (GC-MS)-based metabolomic profiling of protic metabolites, particularly amino-carboxylic species in biological matrices. The sample preparation is carried out directly in aqueous samples and uses simultaneous in situ heptafluorobutyl chloroformate (HFBCF) derivatization and dispersive liquid-liquid microextraction (DLLME), followed by GC-MS analysis in single-ion monitoring (SIM) mode. The protocol involves ten simple pipetting steps and provides quantitative analysis of 132 metabolites by using two internal standards. A comment on each analytical step and explaining notes are provided with particular attention to the GC-MS analysis of 112 physiological metabolites in human urine.
- MeSH
- Urinalysis methods MeSH
- Biomarkers urine MeSH
- Fluorocarbons chemistry MeSH
- Formates chemistry MeSH
- Humans MeSH
- Metabolomics methods MeSH
- Liquid Phase Microextraction methods MeSH
- Gas Chromatography-Mass Spectrometry methods MeSH
- Check Tag
- Humans MeSH
- Publication type
- Journal Article MeSH
- Research Support, Non-U.S. Gov't MeSH
A simple and rapid method for the determination of the methylene blue active substances assay based on in-syringe automation of magnetic stirring-assisted dispersive liquid-liquid microextraction was developed. The proposed method proved to be valid for the determination of anionic surfactant in waste, pond, well, tap, and drinking water samples. Sample mixing with reagents, extraction and phase separation were performed within the syringe of an automated syringe pump containing a magnetic stirring bar for homogenization and solvent dispersion. The syringe module was used upside-down to enable the use of chloroform as an extraction solvent of higher density than water. The calibration was found to be linear up to 0.3mg/L using only 200 µL of solvent and 4 mL of sample. The limits of detection (3σ) and quantification (10σ) were 7.0 µg/L and 22 µg/L, respectively. The relative standard deviation for 10 replicate determinations of 0.1mg/L SBDS was below 3%. Concentrations of anionic surfactants in natural water samples were in the range of 0.032-0.213 mg/L and no significant differences towards the standard method were found. Standard additions gave analyte recoveries between 95% and 106% proving the general applicability and adequateness of the system to MBSA index determination. Compared to the tedious standard method requiring up to 50 mL of chloroform, the entire procedure took only 345 s using 250-times less solvent.
- MeSH
- Automation * MeSH
- Biological Assay methods MeSH
- Water Pollutants, Chemical analysis MeSH
- Syringes MeSH
- Limit of Detection MeSH
- Magnetics * MeSH
- Methylene Blue analysis MeSH
- Liquid Phase Microextraction methods MeSH
- Surface-Active Agents analysis MeSH
- Solvents chemistry MeSH
- Publication type
- Journal Article MeSH
- Research Support, Non-U.S. Gov't MeSH
We have developed a new microextraction technique for equilibrium, non-exhaustive analyte preconcentration from aqueous solutions into organic solvents lighter than water. The key point of the method is application of specially designed and optimized bell-shaped extraction device, BSED. The technique has been tested and applied to the preconcentration of selected volatile and semi volatile compounds which were determined by gas chromatography/mass spectrometry in spiked water samples. The significant parameters of the extraction have been found using chemometric procedures and these parameters were optimized using the central composite design (CCD) for two solvents. The analyte preconcentration factors were in a range from 8.3 to 161.8 (repeatability from 7 to 14%) for heptane, and 50.0-105.0 (repeatability from 0 to 5%) for tert-butyl acetate. The reproducibility of the technique was within 1-8%. The values of limits of detection and determination were 0.1-3.3 ng mL(-1) for heptane and 0.3-10.7 ng mL(-1) for tert-butyl acetate. The new microextraction technique has been found to be a cheap, simple and flexible alternative to the common procedures, such as SPME or LLME. This BSED-LLME technique can also be combined with other separation methods, e.g., HPLC or CE.
- MeSH
- Water Pollutants, Chemical analysis isolation & purification MeSH
- Equipment Design MeSH
- Liquid Phase Microextraction instrumentation methods MeSH
- Mineral Waters analysis MeSH
- Drinking Water analysis MeSH
- Gas Chromatography-Mass Spectrometry methods MeSH
- Reproducibility of Results MeSH
- Water analysis MeSH
- Publication type
- Journal Article MeSH
- Evaluation Study MeSH
- Research Support, Non-U.S. Gov't MeSH
